Home » Flat Heads And Round Fenders: 1953 Ford Customline vs 1954 Hudson Wasp

Flat Heads And Round Fenders: 1953 Ford Customline vs 1954 Hudson Wasp

Sbsd 5 26 2023
ADVERTISEMENT

Happy Friday! We’ve made it to the cusp of a three-day weekend, here in the U.S. anyway. Memorial Day weekend marks the unofficial start of summer for most folks, but it’s also a time to look back and remember how we got here, and who we have to thank. In that spirit, we’re going to look at a couple of uncommon ’50s sedans, perfect for summertime cruising and guaranteed to help you strike up conversations with the oldtimers outside the VFW hall. But first, let’s see where we ended up with yesterday’s wagons:

Screen Shot 2023 05 25 At 5.50.52 Pm

Vidframe Min Top
Vidframe Min Bottom

Looks like the immortal diesel Benz lives to fight another day. Lots of folks sounded scared off by undiagnosed overheating issues with the Scion, and I don’t blame them. Apart from electrical gremlins, cooling system issues are my least favorite car problem to troubleshoot.

Today’s choices are dead-easy to troubleshoot compared to modern cars. There’s just not that much to them. Even the engines have lower parts counts, because these are both flathead engines. The valves, instead of being above the piston tops, are alongside them, and open upwards into a sort of elongated combustion chamber. It’s not as efficient as an overhead valve design, but it has half the moving parts. Better yet, both these engines run perfectly already, so all you have to do for now is enjoy them. Let’s check them out.

1953 Ford Customline sedan – $8,750

00p0p Dgsvttfun5g 0da09s 1200x900

ADVERTISEMENT

Engine/drivetrain: 239 cubic inch flathead V8, three-speed manual with overdrive, RWD

Location: Kennewick, WA

Odometer reading: 113,000 miles

Runs/drives? Yep!

Ford’s legendary flathead V8, introduced way back in 1932, was already a dinosaur when this car was built. Oldsmobile and Cadillac had wildly popular overhead valve V8s out, and Chrysler had just introduced the FirePower V8, precursor to the famous Hemi, two years earlier. Ford’s flathead may have been the king of the hot rod scene, but it was outclassed in showrooms. The rest of the car was all-new in 1952, and already beginning the trend towards lower, flatter, wider cars that would dominate the next two decades of car design.

ADVERTISEMENT

00t0t 3i7tcr4nfmd 0ci0t2 1200x900

Cars of this era won’t win any safety awards, however. Someone added seatbelts to this one, a token gesture to keep you away from the non-collapsing steering column and steel dashboard if the unthinkable happened. Ralph Nader may have been a killjoy when it came to the Corvair, but he wasn’t wrong about the auto industry’s safety-last track record. But in this day and age, you’re not taking the kids to daycare in something like this, so it doesn’t matter as much.

00l0l 96s44etlbyq 0ci0t2 1200x900

Someone has put a lot of work into this old Ford to get it ready for summertime cruising, however. The flathead runs like a top, and rumbles through dual exhausts with glasspacks. They also upgraded the braking system to a dual-servo power master cylinder, and added front wheel disc brakes. Strangely, they’ve left the original six-volt electrical system in place.

01414 Cypiwveirdh 0ci0t2 1200x900

ADVERTISEMENT

Condition-wise, it looks pretty good. The interior is nice, and the paint is mostly shiny, and I don’t see any signs of serious rust, though the seller notes that there is a little in the bottoms of the doors. It does have some cracked windows (flat plate glass in these, no tempered safety glass here), but plenty of glass shops can help you with that.

1954 Hudson Wasp – $10,000

00202 6pnoih26s1vz 0t20t2 1200x900

Engine/drivetrain: 232 cubic inch flathead inline 6, three-speed manual, RWD

Location: Stony Point, NY

Odometer reading: 57,000 miles

ADVERTISEMENT

Runs/drives? Sure does!

Hudson’s flathead inline six was every bit as far behind the times as Ford’s flathead V8. 1954 was the last year before Hudson merged with Nash-Kelvinator to create American Motors, and the Hudson nameplate, and its line of flathead sixes dating back to 1916, wouldn’t make it past 1957. But in 1954, Hudson was going out in a blaze of NASCAR glory, with this car’s big brother, the Hornet, winning everything in sight. Hudson’s big flathead six was part of that winning formula, as was the low center of gravity from a body sitting inside the perimeter of the frame, rather than being perched atop it. This design was copied by every other carmaker in short order, and made the “longer, lower, wider” era possible.

00e0e 2owdtelyu9dz 0t20ci 1200x900

This Hudson Wasp doesn’t have the Hornet’s big race-winning 308 cubic inch engine. It makes do with 232 cubic inches and a single-barrel carburetor. This was good for only 112 horsepower, but like all low-revving sixes back then, approximately nine zillion pound-feet of torque. This one runs very well, the seller says. The car passed a New York state inspection test, which is a good sign.

00k0k Iomdeb5azxfz 0t20t2 1200x900

ADVERTISEMENT

Inside, it’s in good honest shape, with one popped seam on the seat and a little bit of wear and tear, but it all looks original, which is impressive for a 69-year-old car. The seller says it was garaged for decades, which accounts for the low mileage as well.

00909 7i8sstvif3mz 0t20t2 1200x900

The car was repainted sometime in the ’70s, and while it’s not the shiniest thing around, it also isn’t rusty. There are a couple of underside photos in the listing, and it’s nice and clean underneath as well. And it looks like the blue is its original color. The chrome all looks good, but the seller says some replacement pieces are included.

If you go to a car show with a lot of ’50s American iron, it can be easy to assume that nothing before the ’55 Chevy and its small-block OHV V8 matters much. But that obviously isn’t true; here we have the last gasp of the very first affordable V8 – the engine that launched the entire hot-rodding scene, and the first engine to dominate stock-car racing – a simple old-fashioned valve-in-block inline six. Even better, the cars that these two legendary engines are installed in are good-looking and ready to roll. Which one will it be?

ADVERTISEMENT

(Image credits: Craigslist sellers)

Share on facebook
Facebook
Share on whatsapp
WhatsApp
Share on twitter
Twitter
Share on linkedin
LinkedIn
Share on reddit
Reddit
Subscribe
Notify of
37 Comments
Inline Feedbacks
View all comments
Manwich Sandwich
Manwich Sandwich
1 year ago

A couple of things… first…
and Chrysler had just introduced the FirePower V8, precursor to the famous Hemi,”

The FirePower V8 WAS a Hemi.

This Hudson Wasp doesn’t have the Hornet’s big race-winning 308 cubic inch engine. It makes do with 232 cubic inches and a single-barrel carburetor. This was good for only 112 horsepower”

It should also be noted that not only will it have more torque, it has a bit more HP than the 239 Ford Flathead V8 as well.

My vote is for the Hudson. I like how it looks and apparently it goes and turns better than the Fords of that era.

David Saunders
David Saunders
1 year ago

Normally I’d lean move towards the oddball but it would be the Ford for me in this case. Styling inside and out is just better. This is not my favourite year of that Hudson design.

Masterbuilder
Masterbuilder
1 year ago

Hudson all the way. Build a 7X engine, swap it in and rumble around town with that cammed 6 cylinder exhaust note trailing you.

88CieraXC
88CieraXC
1 year ago

Ford, “Fix Or Repair Daily” came from thus era. I’m rocking the hudson.

JDE
JDE
1 year ago

Tough one. The OD manual with a flatter is pretty cool.in theory, but the Hidson looks so good and the 6 is superior in design in this case. I would go hudson

Gary Lynch
Gary Lynch
1 year ago

Both cars have nice big rear seats. Plenty of room to spread out. Alas, I miss those days…

Dodsworth
Dodsworth
1 year ago

Her name will be Maybellene. Nothing outruns my V8 Ford.

37
0
Would love your thoughts, please comment.x
()
x